I want to repaint my mech keyboard
And i dont know what is the tool for it and what is type of paint should i use
My kb Body is from Plastic
Image no longer available
Sory for bad quality pic , potato webcam.
I want to repaint my mech keyboard
And i dont know what is the tool for it and what is type of paint should i use
My kb Body is from Plastic
Image no longer available
Sory for bad quality pic , potato webcam.
Make sure to thoroughly clean your keyboard before hand. Get all the oils and shit off everything. Buy some paint that works specifically with the board (metal, plastic). Use many lights coats with good time between to get good drying. Then use a protective overcoat in multiple coats to make sure the paint doesn't chip. Or just get a cool light up one.
losi wroteMake sure to thoroughly clean your keyboard before hand. Get all the oils and shit off everything. Buy some paint that works specifically with the board (metal, plastic). Use many lights coats with good time between to get good drying. Then use a protective overcoat in multiple coats to make sure the paint doesn't chip. Or just get a cool light up one.
hmm , by the way
what is the tool should i use
just spray it wit the canned one or airbrush ?
I wonder if this works on laptops! 
Do you just want to paint the body, or the keycaps too?
I personally wouldn't paint the keycaps, I'd just get a set of nice PBT keycaps in a colour of your choice.
For painting the body, you'd want to dismantle the kb first, then it's usually recommended to give the surface a rub down with some fine/very fine sand paper. (Unless the kb is heavily textured)
Make sure the kb is dry and clean, then apply one or two coats of plastic primer, sand it down a little, then a few coats of your paint.
You can just use normal spray paint, but perhaps paint intended for plastics would be more suitable.
As for a top coat, it kind of depends on your colour coat, sometimes you need to apply a top, some times not, but it does offer an extra layer of protection, and you can get it in satin as well as glossy.
There are some great guides on painting plastics out there, with just a wee bit of searching.
Amato Masaki wrotejust spray it wit the canned one or airbrush ?
An airbrush would require an air compressor, if you don't have one, spray cans are perfectly fine for the job.
Backlash wroteI wonder if this works on laptops!
No reason why it shouldn't, but you'd need to take it apart, remove all the plastic parts, you don't want paint going inside your laptop =P
Also some laptops can get kinda hot, while it should be fine for most paints, it's worth bearing in mind.
>#67687
Thanks , a big help
.